JB/T 11173-2011 数控回转工作台
作者:标准资料网 时间:2024-05-16 00:50:07 浏览:8198
来源:标准资料网
基本信息
| 标准名称： | 数控回转工作台 |
| 英文名称： | NC rotary table |
| 中标分类： |
机械 >>
金属切削机床 >>
机床辅具与附件 |
| ICS分类： |
机械制造 >>
机床装置 >>
分度和刀具/工件夹持装置
|
| 发布部门： | 中华人民共和国工业和信息化部 |
| 发布日期： | 2011-05-18 |
| 实施日期： | 2011-08-01 |
| 首发日期： | |
| 作废日期： | |
| 归口单位： | 全国金属切削机床标委会 |
| 起草单位： | 烟台环球机床附件集团有限公司 |
| 出版社： | 机械工业出版社 |
| 出版日期： | 2011-08-01 |
适用范围
没有内容
前言
没有内容
目录
没有内容
引用标准
没有内容
所属分类： 机械 金属切削机床 机床辅具与附件 机械制造 机床装置 分度和刀具/工件夹持装置
Product Code:SAE AS21230
Title:Bearing, Plain, Self-Aligning, Grooved Outer Ringer Tfe Lined, Wide
Issuing Committee:Acbg Plain Bearing Committee
Scope:No scope available.Product Code:SAE J2748
Title:VHDL-AMS Statistical Analysis Packages
Issuing Committee:Electronic Design Automation Standards Committee
Scope:This document specifies the interface and the behavior of the VHDL-AMS packages for use in modeling statistical behavior. These packages are useful in defining the statistical variation of parameters of electrical, electronic, and mechatronic components and sub-systems. These can then be used with simulation tools to analyze the performance and reliability of systems composed of these components and sub-systems. Providing a standard definition of the package interfaces and their behavior is intended to facilitate the exchange of models between component and system manufacturers and the use of different CAE simulation tools.The SAE statistical package supports the statistical modeling of design parameters subject to tolerances for designs described using the VHDL or VHDL-AMS languages. The performance of a design that uses this package to model parameter tolerances may be analyzed by a Monte Carlo simulation, which consists of multiple simulation runs of the design, each run with a different set of parameter values according to their statistical distributions. The Monte Carlo simulation will yield an estimate of the behavior of the design subject to the parameter tolerances. Additionally, the package may be used to perform an Extreme Value Analysis of a design, that is, an analysis that computes the worst case behavior of the design.The SAE statistical package does not support other statistical modeling needs, for example the modeling of statistical variations of the arrival of events in a queue, or any other situation where a value exhibits a statistical behavior during a single simulation.
